Copy Paper - Kyocera Mita DC-2560 Service Manual

1-2-1 Drum
Note the following when handling or storing the drum.
• While the cleaning unit and the developing unit are detached from the copier or the
drum is being replaced, make sure that the drum surface is protected from strong,
direct light.
• Keep the drum at an ambient temperature between –20°C/–4°F and 40°C/104°F and
humidity not higher than 85% RH. Avoid abrupt changes in temperature and humidity
even within the allowable ranges.
• Avoid exposing the drum to gases which are harmful to or may affect the quality of the
drum.
• Handle the drum with care. Avoid impacts. Never touch the drum surface. If it is
stained, clean it.
• If the copier is left open for more than 5 minutes for maintenance, remove the drum
and store it in the storage bag.
Reference: If the drum is left exposed to moderate light of 1000 lx for 5 minutes and
then stored in the dark for 5 minutes, the photoconductivity of the drum will
recover enough to allow copying with no practical after effect from the
exposure to light. However, exposure to direct sunlight (100,000 to
300,000 lx) should be absolutely avoided.
1-2-2 Developer and toner
Store the developer and toner in a cool, dark place. Avoid direct light, high humidity and
temperature.
1-2-3 Dehumidifier
The dehumidifier prevents condensation inside the copier. As long as the power plug is
connected, power is supplied to the dehumidifier even when the main switch is turned
off.
When the cassette heater (optional) is installed, as long as the power plug is connected,
power is supplied to the cassette heater even when the main switch is turned off.
Do not unplug the power cord when the humidity is 70% RH or higher.
If the copier will not be used for a long time, unplug the power cord.
You can select whether you wish to operate the dehumidifier by means of the
dehumidifier ON/OFF switches. The dehumidifier switches should be kept ON during
periods of high humidity (70% RH or higher).

1-2-4 Copy paper

Store copy paper away from direct sunlight or high humidity. If the copier will not be
used for a long time, take out the paper from the cassette and wrap it in the original
wrapping paper.
1AH
1-2-1