1AH
3-3-3 Main charging section
( 1 ) Replacing the charger wire and main charger grid
Take the following procedure when the charger wire is broken or to be replaced.
Precautions
• Use the specified tungsten wire for the charger wire.
• The part of the wire wrapped around the charger spring must not protrude from the
charger housing.
• The cut end of the charger wire must not protrude more than 2 mm from under the
charger wire retainer pin.
• Use a clean, undamaged tungsten charger wire.
• Keep the charger wire taut by stretching the charger spring.
• Clean the main charger shield when replacing the charger wire.
Do not use organic solvents such as alcohol and thinner to clean the main charger
shield.
3-3-28