Unpacking And Installation; 1 ) Installation Environment - Kyocera Mita DC-2560 Service Manual

3-1-1 Unpacking and installation

( 1 ) Installation environment

1. Temperature: 10-35°C/50-95°F
2. Humidity: 15-85%RH
3. Power supply: 230 V AC, 8 A
4. Power source frequency: 50 Hz ± 0.3%
5. Installation location
• Avoid direct sunlight or bright lighting. Make sure that the photoconductor will not
be exposed to direct sunlight or other strong light when removing paper jams.
• Avoid extremes of temperature and humidity, abrupt ambient temperature
changes, and hot or cold air directly hitting the machine.
• Avoid dust and vibration.
• Choose a surface capable of supporting the weight of the machine.
• Place the machine on a level surface (maximum allowable inclination: 1°).
• Avoid air-borne substances that may adversely affect the machine or degrade the
photoconductor, such as mercury, acidic and alkaline vapors, inorganic gases,
NOx, SOx gases and chlorine-based organic solvents.
• Select a room with good ventilation.
6. Allow sufficient access for proper operation and maintenance of the machine.
Machine front: 100 cm/39
Machine rear: 10 cm/4"
Machine right: 70 cm/27
Machine left: 60 cm/23
c
f
7. Full System Weight =
Copier + Special tray + Duplex unit + RADF + Sorter: Approx. 154 kg / 339 lbs
3
/ "
8
5
/ "
8
5
/ "
8
d
e
Figure 3-1-1 Installation dimensions
b
a : 595 mm
b : 1259 mm
c : 541 mm
a
d : 1199 mm
e : 610 mm
(exept for duct (height)
of the rear cover.
duct hight = 30 mm)
f : 1095 mm
1AH
3-1-1