2 ) Detaching And Refitting The Optical Thermostat - Kyocera Mita DC-2560 Service Manual

1AH

( 2 ) Detaching and refitting the optical thermostat

Check or replace the halogen lamp as follows.
* The optical thermostat is reset by pressing the button after it has been triggered.
If it does not resume normal operation, replace the thermostat.
* After replacing the optical thermostat, proceed to ( 6 ) Adjusting focus (refitting of light
source unit 1) (see page 3-3-51).
Caution: Use the specified thermostat for replacement. Do not substitute a simple wire
or similar; otherwise, the copier will be seriously damaged.
Procedure
1. Move light source unit 1 to the center of the machine (notch).
2. Remove the two screws, and then remove light source unit 1 rotating in the direction
of the arrow.
Screw
3-3-34
Light source
unit 1
Figure 3-3-39
Screw