Show Ip Access-Group; Mac Acls; Table 4-49 Mac Acl Commands - Samsung iES4028F Management Manual

4
Command Line Interface
Example
Console(config)#int eth 1/25
Console(config-if)#ip access-group david in
Console(config-if)#
Related Commands
show ip access-list (4-181)

show ip access-group

This command shows the ports assigned to IP ACLs.
Command Mode
Privileged Exec
Example
Console#show ip access-group
Interface ethernet 1/25
IP access-list david in
Console#
Related Commands
ip access-group (4-181)

MAC ACLs

The commands in this section configure ACLs based on hardware addresses,
packet format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports.
Command
access-list mac
permit, deny
show mac access-list
mac access-group
show mac access-group
4-182

Table 4-49 MAC ACL Commands

Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and
destination address, packet format, and Ethernet type
Displays the rules for configured MAC ACLs
Adds a port to a MAC ACL
Shows port assignments for MAC ACLs
Mode Page
GC 4-183
MAC-ACL 4-184
PE 4-185
IC 4-186
PE 4-186