System Status Commands; Show Startup-Config; Table 4-9 System Status Commands - Samsung iES4028F Management Manual

System Status Commands

This section describes commands used to display system information.
Command

show startup-config

show running-config
show system
show users
show version
show memory
show startup-config
This command displays the configuration file stored in non-volatile memory that is
used to start up the system.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
• Use this command in conjunction with the show running-config command to
compare the information in running memory to the information stored in
non-volatile memory.
• This command displays settings for key command modes. Each mode group
is separated by "!" symbols, and includes the configuration mode command,
and corresponding commands. This command displays the following
information:
- Switch's MAC address
- SNTP and NTP server settings
- 802.1Q tunnel settings
- Power over Ethernet settings
- Broadcast storm control settings
- SNMP community strings
- Users (names and access levels)
- Event log settings
- VLAN database (VLAN ID, name and state)
- VLAN configuration settings for each interface
- Multiple spanning tree instances (name and interfaces)
- IP address configured for the switch

Table 4-9 System Status Commands

Function
Displays the contents of the configuration file (stored in flash
memory) that is used to start up the system
Displays the configuration data currently in use
Displays system information
Shows all active console and Telnet sessions, including user
name, idle time, and IP address of Telnet clients
Displays version information for the system
Shows the location and size of free system memory
System Management Commands
4
Mode Page
PE 4-27
PE 4-29
NE, PE 4-31
NE, PE 4-31
NE, PE 4-32
PE 4-33
4-27