Samsung iES4028F Management Manual page 9

• "spanning-tree port-bpdu-flooding" on page 4-240.
• Syntax and Default Setting under "spanning-tree mst cost" on page 4-244.
• Syntax for "switchport mode" on page 4-257.
• Removed note under "switchport ingress-filtering" on page 4-258.
• Removed note under "switchport allowed vlan" on page 4-260.
• Command Usage under "switchport allowed vlan" on page 4-260.
• Syntax for "show vlan" on page 4-262.
• Limitations for QinQ under "Configuring IEEE 802.1Q Tunneling" on page 4-263.
• Command Usage under "switchport dot1q-tunnel mode" on page 4-264.
• "Configuring Port-based Traffic Segmentation" on page 4-267.
• Removed references to isolated VLAN option from "Configuring Private VLANs" on
page 4-271 and related commands which had supported this option.
• Removed switchport private-vlan isolated command.
• Command Usage under "switchport voice vlan" on page 4-282.
• Command Usage under "queue mode" on page 4-308.
• Removed queue bandwidth command.
• Configuration guidelines under "Quality of Service Commands" on page 4-316.
• Introduction and Syntax for "set" on page 4-320.
• Command Usage under "mvr (Global Configuration)" on page 4-341.
• Command Usage under "mvr (Interface Configuration)" on page 4-343.
• Command Usage under "ip default-gateway" on page 4-348.
• General Security Measures under "Software Specifications" on page A-1.
• Updated entries for Standards under "Software Specifications" on page A-1.
• Updated entries for Management Information Bases under "Software Specifications" on
page A-1.
April 2008 Revision
This was the first revision of this guide for the Ubigate iES4028FP.
ix