Samsung iES4028F Management Manual page 8

• Command Usage and Command Attributes under "Configuring MVR Interface Status"
on page 3-270.
• Command Usage under "Switch Clustering" on page 3-273.
• Introduction under "UPnP" on page 3-277.
• Command Usage under "jumbo frame" on page 4-33.
• Command Usage under "copy" on page 4-35.
• Syntax under "show log" on page 4-55.
• Using Switch Clustering under "Switch Cluster Commands" on page 4-73.
• Introduction under "UPnP Commands" on page 4-77.
• "Debug Commands" on page 4-80.
• Syntax for "radius-server host" on page 4-105.
• Introduction, Default Setting and Command Usage under "radius-server attribute 4" on
page 4-107.
• Syntax for "radius-server key" on page 4-107.
• Syntax for "tacacs-server host" on page 4-110.
• Syntax for "tacacs-server key" on page 4-111.
• Introduction for "aaa group server" on page 4-114.
• Syntax for "show accounting" on page 4-122.
• "ip telnet server" on page 4-126.
• Authentication section of Configuration Guidelines under "Secure Shell Commands" on
page 4-127.
• Command Usage under "dot1x re-authenticate" on page 4-140.
• Command Usage under "dot1x re-authentication" on page 4-140.
• Command Usage under "port security" on page 4-149.
• Introduction under "Network Access (MAC Address Authentication)" on page 4-150.
• Removed network-access dynamic-qos, network-access link-detection,
network-access link-detection link-down, network-access link-detection link-up, and
network-access link-detection link-up-down commands from "Network Access (MAC
Address Authentication)" on page 4-150.
• Removed web-auth login-fail-page-url, web-auth login-page-url, and web-auth
login-success-page-url commands from "Web Authentication" on page 4-159.
• Command Usage under "ip dhcp snooping information option" on page 4-169.
• Removed reference to static DHCP Snooping entries from Command Usage under "ip
source-guard" on page 4-172 and "ip source-guard binding" on page 4-174.
• Introduction, Syntax and Command Usage under "permit, deny (Extended ACL)" on
page 4-179.
• Removed Command Usage from "ACL Information" on page 4-187.
• Command Usage under "speed-duplex" on page 4-189.
• "media-type" on page 4-193.
• "giga-phy-mode" on page 4-194.
• Default Setting under "switchport packet-rate" on page 4-195.
• "lacp active/passive" on page 4-209.
• Software Version parameter in Table 4-60, "show power mainpower parameters," on
page 4-218.
• Syntax and Command Usage under "port monitor" on page 4-219.
• "spanning-tree system-bpdu-flooding" on page 4-231.
• Syntax and Default Setting under "spanning-tree cost" on page 4-237.
viii