Rate Limit Commands; Rate-Limit; Table 4-62 Rate Limit Commands - Samsung iES4028F Management Manual

Rate Limit Commands

This function allows the network manager to control the maximum rate for traffic
received on an interface. Rate limiting is configured on interfaces at the edge of a
network to limit traffic into the network. Packets that exceed the acceptable amount
of traffic are dropped.
Rate limiting can be applied to individual ports or trunks. When an interface is
configured with this feature, the traffic rate will be monitored by the hardware to
verify conformity. Non-conforming traffic is dropped.
Command

rate-limit

rate-limit
Use this command to define the rate limit level for a specific interface. Use this
command without specifying a rate to restore the default rate limit. Use the no form
to restore the default status of disabled.
Syntax
rate-limit {input | output} [rate]
no rate-limit <input | output>
• input – Input rate limit
• output – Input rate limit
• rate – The traffic rate limit level. Range: 64-100000 kilobits per second for
100 Mbps ports; 64-1000000 kilobits per second for 1 Gbps ports
Default Setting
Status: Disabled
Rate Limit: 100000 kilobits per second for 100 Mbps ports; 1000000 kilobits
per second for 1 Gbps ports
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rate-limit input 2000
Console(config-if)#
Table 4-62 Rate Limit Commands
Function
Configures the maximum input rate for a port
Rate Limit Commands
Mode
IC
4
Page
4-221
4-221