Multicast Vlan Registration Commands; Mvr (Global Configuration); Table 4-91 Multicast Vlan Registration Commands - Samsung iES4028F Management Manual

Example
Console#show ip igmp throttle interface ethernet 1/1
Eth 1/1 Information
Status : TRUE
Action : Deny
Max Multicast Groups : 32
Current Multicast Groups : 0
Console#

Multicast VLAN Registration Commands

This section describes commands used to configure Multicast VLAN Registration
(MVR). A single network-wide VLAN can be used to transmit multicast traffic (such
as television channels) across a service provider's network. Any multicast traffic
entering an MVR VLAN is sent to all subscribers. This can significantly reduce to
processing overhead required to dynamically monitor and establish the distribution
tree for a normal multicast VLAN. Also note that MVR maintains the user isolation
and data security provided by VLAN segregation by passing only multicast traffic
into other VLANs to which the subscribers belong.
Command Function
mvr Globally enables MVR, statically configures MVR group address(es), or
specifies the MVR VLAN identifier
mvr Configures an interface as an MVR receiver or source port, enables
immediate leave capability, or configures an interface as a static
member of the MVR VLAN
show mvr Shows information about the global MVR configuration settings, the
interfaces attached to the MVR VLAN, or the multicast groups assigned
to the MVR VLAN

mvr (Global Configuration)

This command enables Multicast VLAN Registration (MVR) globally on the switch,
statically configures MVR multicast group IP address(es) using the group keyword,
or specifies the MVR VLAN identifier using the vlan keyword. Use the no form of
this command without any keywords to globally disable MVR. Use the no form with
the group keyword to remove a specific address or range of addresses. Or use the
no form with the vlan keyword restore the default MVR VLAN.
Syntax
[no] mvr [group ip-address [count] | vlan vlan-id]
• ip-address - IP address for an MVR multicast group.
(Range: 224.0.1.0 - 239.255.255.255)
• count - The number of contiguous MVR group addresses. (Range: 1-255)
• vlan-id - MVR VLAN ID (Range: 1-4094)

Table 4-91 Multicast VLAN Registration Commands

Multicast Filtering Commands
Mode
GC
IC
PE
4
Page
4-341
4-343
4-344
4-341