Configuring Parameters For Lacp Groups - Samsung iES4028F Management Manual

CLI – The following example configures LACP parameters for ports 1-4. Ports 1-4
are used as active members of the LAG.
Console(config)#interface ethernet 1/1
Console(config-if)#lacp actor system-priority 3
Console(config-if)#lacp actor admin-key 120
Console(config-if)#lacp actor port-priority 128
Console(config-if)#exit
. .
.
Console(config)#interface ethernet 1/4
Console(config-if)#lacp actor system-priority 3
Console(config-if)#lacp actor admin-key 120
Console(config-if)#lacp actor port-priority 512
Console(config-if)#end
Console#show lacp sysid
Port Channel
-------------------------------------------------------------------------
1
2
3
4
Console#show lacp 1 internal
Port channel : 1
-------------------------------------------------------------------------
Oper Key : 120
Admin Key : 0
Eth 1/1
-------------------------------------------------------------------------
LACPDUs Internal:
LACP System Priority: 3
LACP Port Priority:
Admin Key:
Oper Key:
Admin State : defaulted, aggregation, long timeout, LACP-activity
Oper State:
.
.
.

Configuring Parameters for LACP Groups

Use the Aggregator page to configure system parameters which apply to specific
LACP groups.
Command Attributes
• Admin Key – LACP administration key is used to identify a specific link
aggregation group (LAG) during local LACP setup on the switch. (Range: 0-65535)
Ports are only allowed to join the same LAG if (1) the LACP port system priority
matches, (2) the LACP port admin key matches, and (3) the LACP port channel
admin key matches (if configured).
If the port channel admin key is not set when a channel group is formed (that is, it
has the null value of 0), this key is set to the same value as the port admin key used
by the interfaces that joined the group. Note that when the LAG is no longer used,
the port channel admin key is reset to 0.
System Priority
3
32768
32768
32768
30 sec
128
120
120
distributing, collecting, synchronization,
aggregation, long timeout, LACP-activity
System MAC Address
00-12-CF-31-31-31
00-12-CF-31-31-31
00-12-CF-31-31-31
00-12-CF-31-31-31
3
Port Configuration
4-188
4-205
4-206
4-208
4-209
4-209
3-141