Lacp Active/Passive; Show Lacp - Samsung iES4028F Management Manual

lacp active/passive

This command configures active or passive LACP initiation mode. Use the no form
to restore the default setting.
Syntax
lacp {actor | partner} {active | passive}
no lacp {actor | partner}
• actor - The local side an aggregate link.
• partner - The remote side of an aggregate link.
• active - Enables active initiation of LACP negotiation on a port, automatically
sending LACP negotiation packets.
• passive - Enables passive initiation of LACP negotiation on a port, which
starts negotiations only if an LACP device is detected at the other end of the
link.
Default Setting
active
Command Mode
Interface Configuration (Ethernet)
Command Usage
Regardless of the LACP initiation mode, if the target switch has also enabled
LACP on the connected ports and negotiations are successfully completed,
the trunk will be activated automatically.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor active
Console(config-if)#

show lacp

This command displays LACP information.
Syntax
show lacp [port-channel] {counters | internal | neighbors | sysid}
• port-channel - Local identifier for a link aggregation group. (Range: 1-8)
• counters - Statistics for LACP protocol messages.
• internal - Configuration settings and operational state for local side.
• neighbors - Configuration settings and operational state for remote side.
• sysid - Summary of system priority and MAC address for all channel
groups.
Default Setting
Port Channel: all
Link Aggregation Commands
4
4-209