Line Commands; Table 4-13 Line Commands - Samsung iES4028F Management Manual

4
Command Line Interface
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified unit number and file type.
• If the file contains an error, it cannot be set as the default file.
Example
Console(config)#boot system config: startup
Console(config)#
Related Commands
dir (4-38)
whichboot (4-39)

Line Commands

You can access the onboard configuration program by attaching a VT100
compatible device to the server's serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Command
line
login
password
timeout login
response
exec-timeout
password-thresh
silent-time*
databits*
parity*
speed*
stopbits*
disconnect
show line
* These commands only apply to the serial port.
4-40

Table 4-13 Line Commands

Function
Identifies a specific line for configuration and starts the line
configuration mode
Enables password checking at login
Specifies a password on a line
Sets the interval that the system waits for a user to log into the
CLI
Sets the interval that the command interpreter waits until user
input is detected
Sets the password intrusion threshold, which limits the number
of failed logon attempts
Sets the amount of time the management console is
inaccessible after the number of unsuccessful logon attempts
exceeds the threshold set by the password-thresh command
Sets the number of data bits per character that are interpreted
and generated by hardware
Defines the generation of a parity bit
Sets the terminal baud rate
Sets the number of the stop bits transmitted per byte
Terminates a line connection
Displays a terminal line's parameters
Mode Page
GC 4-41
LC 4-41
LC 4-42
LC 4-43
LC 4-44
LC 4-44
LC 4-45
LC 4-46
LC 4-46
LC 4-47
LC 4-47
PE 4-48
NE, PE 4-48