Configuring Cluster Members; Figure 3-158 Cluster Configuration - Samsung iES4028F Management Manual

3
Configuring the Switch
• Cluster IP Pool – An "internal" IP address pool that is used to assign IP addresses
to Member switches in the cluster. Internal cluster IP addresses are in the form
10.x.x.member-ID. Only the base IP address of the pool needs to be set since
Member IDs can only be between 1 and 36. Note that y
IP pool when the switch is currently in Commander mode. Commander mode must first
be disabled. (Default: 10.254.254.1)
• Number of Members – The current number of Member switches in the cluster.
• Number of Candidates – The current number of Candidate switches discovered
in the network that are available to become Members.
Web – Click Cluster, Configuration.
CLI – This example first enables clustering on the switch, sets the switch as the
cluster Commander, and then configures the cluster IP pool.
Console(config)#cluster
Console(config)#cluster commander
Console(config)#cluster ip-pool 10.2.3.4
Console(config)#exit
Console#show cluster
Role:
Interval heartbeat:
Heartbeat loss count: 3
Number of Members:
Number of Candidates: 0
Console#

Configuring Cluster Members

Use the Member Configuration page to add Candidate switches to the cluster as
Members.
Command Attributes
• Member ID – Specify a Member ID number for the selected Candidate switch.
(Range: 1-36)
• MAC Address – Select a discovered switch MAC address from the Candidate
Table, or enter a specific MAC address of a known switch.
3-274

Figure 3-158 Cluster Configuration

commander
30
0
ou cannot change the cluster
4-73
4-74
4-75
4-76