Shutdown; Switchport Packet-Rate - Samsung iES4028F Management Manual

shutdown

This command disables an interface. To restart a disabled interface, use the no
form.
Syntax
[no] shutdown
Default Setting
All interfaces are enabled.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This command allows you to disable a port due to abnormal behavior
(e.g., excessive collisions), and then reenable it after the problem has been
resolved. You may also want to disable a port for security reasons.
Example
The following example disables port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#shutdown
Console(config-if)#

switchport packet-rate

This command configures broadcast and multicast and unknown unicast storm
control. Use the no form to restore the default setting.
Syntax
switchport {broadcast | multicast | unknown-unicast} packet-rate rate
no switchport {broadcast | multicast | unknown-unicast}
• broadcast - Specifies storm control for broadcast traffic.
• multicast - Specifies storm control for multicast traffic.
• unknown-unicast - Specifies storm control for unknown unicast traffic.
• rate - Threshold level as a rate; i.e., kilobits per second.
(Range: 64-100000 for 100 Mbps ports, 64-1000000 for 1 Gbps ports)
Default Setting
Broadcast Storm Control: Enabled, packet-rate limit: 64 kbps
Multicast Storm Control: Disabled
Unknown Unicast Storm Control: Disabled
Command Mode
Interface Configuration (Ethernet)
Interface Commands
4-195
4