Spanning-Tree Cost; Table 4-65 Ieee 802.1D-1998; Table 4-65 Ieee 802.1W-2001; Table 4-66 Ieee 802.1D-1998 - Samsung iES4028F Management Manual

Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
This example disables the spanning tree algorithm for port 5.
Console(config)#interface ethernet 1/5
Console(config-if)#spanning-tree spanning-disabled
Console(config-if)#

spanning-tree cost

This command configures the spanning tree path cost for the specified interface.
Use the no form to restore the default.
Syntax
spanning-tree cost cost
no spanning-tree cost
cost - The path cost for the port. (Range: 1-200,000,000)
(Range: 0 for auto-configuration, 1-65535 for short path cost method
1-200,000,000 for long path cost method)
Port Type
Ethernet
Fast Ethernet
Gigabit Ethernet
Port Type
Ethernet
Fast Ethernet
Gigabit Ethernet
27. Use the spanning-tree pathcost method command on page 4-232 to set the path cost
method.
Table 4-65 Recommended STA Path Cost Range
IEEE 802.1D-1998
50-600
10-60
3-10
Table 4-66 Recommended STA Path Cost
Link Type IEEE 802.1D-1998
Half Duplex
Full Duplex
Trunk
Half Duplex
Full Duplex
Trunk
Full Duplex
Trunk
Spanning Tree Commands
IEEE 802.1w-2001
200,000-20,000,000
20,000-2,000,000
2,000-200,000
100
95
90
19
18
15
4
3
IEEE 802.1w-2001
2,000,000
1,999,999
1,000,000
200,000
100,000
50,000
10,000
5,000
4
27
,
4-237