Assigning Static Multicast Groups To Interfaces; Figure 3-155 Mvr Port Configuration - Samsung iES4028F Management Manual

- Non-MVR – An interface that does not participate in the MVR VLAN. (This is the
default type.)
• Immediate Leave – Configures the switch to immediately remove an interface
from a multicast stream as soon as it receives a leave message for that group.
(This option only applies to an interface configured as an MVR receiver.)
22
• Trunk – Shows if port is a trunk member.
Web – Click MVR, Port or Trunk Configuration.
CLI – This example configures an MVR source port and receiver port, and then
enables immediate leave on the receiver port.
Console(config)#interface ethernet 1/1
Console(config-if)#mvr type source
Console(config-if)#exit
Console(config)#interface ethernet 1/2
Console(config-if)#mvr type receiver
Console(config-if)#mvr immediate
Console(config-if)#

Assigning Static Multicast Groups to Interfaces

For multicast streams that will run for a long term and be associated with a stable set
of hosts, you can statically bind the multicast group to the participating interfaces.
Command Usage
• Any multicast groups that use the MVR VLAN must be statically assigned to it
under the MVR Configuration menu (see"Configuring Global MVR Settings" on
page 3-266).
22. Port Information only.

Figure 3-155 MVR Port Configuration

Multicast VLAN Registration
3
4-343
4-343
4-343
3-271