Setting Passwords; Setting An Ip Address - Samsung iES4028F Management Manual

2
Initial Configuration

Setting Passwords

Note: If this is your first time to log into the CLI program, you should define new
passwords for both default user names using the "username" command, record
them and put them in a safe place.
Passwords can consist of up to 8 alphanumeric characters and are case sensitive.
To prevent unauthorized access to the switch, set the passwords as follows:
1. Open the console interface with the default user name and password "admin" to
access the Privileged Exec level.
2. Type "configure" and press <Enter>.
3. Type "username guest password 0 password," for the Normal Exec level, where
password is your new password. Press <Enter>.
4. Type "username admin password 0 password," for the Privileged Exec level,
where password is your new password. Press <Enter>.
Note: '0' specifies the password in plain text, '7' specifies the password in encrypted
form.
Username: admin
Password:
CLI session with the Ubigate iES4024GP
To end the CLI session, enter [Exit].
Console#configure
Console(config)#username guest password 0 [password]
Console(config)#username admin password 0 [password]
Console(config)#
* This manual covers both the Ubigate iES4028F, iES4028FP and iES4024GP switches. Other than the
differences listed in Table 1-1, "Differences in Switch Models," on page 1-1, there are no other significant
differences. Therefore all of the screen display examples are based on the iES4024GP.

Setting an IP Address

You must establish IP address information for the stack to obtain management
access through the network. This can be done in either of the following ways:
Manual — You have to input the information, including IP address and subnet mask.
If your management station is not in the same IP subnet as the switch, you will also
need to specify the default gateway router.
Dynamic — The switch sends IP configuration requests to BOOTP or DHCP
address allocation servers on the network.
2-4
*
is opened.