3
Configuring the Switch
Web – Click Port, LACP, Aggregator. Set the Admin Key for the required LACP
group, and click Apply.
CLI – The following example sets the LACP admin key for port channel 1.
Console(config)#interface port-channel 1
Console(config-if)#lacp actor admin-key 3
Console(config-if)#
Displaying LACP Port Counters
You can display statistics for LACP protocol messages.
Field
LACPDUs Sent
LACPDUs Received
Marker Sent
Marker Received
Marker Unknown Pkts
Marker Illegal Pkts
3-142
Figure 3-83 LACP Aggregation Group Configuration
Table 3-8 LACP Port Counters
Description
Number of valid LACPDUs transmitted from this channel group.
Number of valid LACPDUs received on this channel group.
Number of valid Marker PDUs transmitted from this channel group.
Number of valid Marker PDUs received by this channel group.
Number of frames received that either (1) Carry the Slow Protocols
Ethernet Type value, but contain an unknown PDU, or (2) are addressed
to the Slow Protocols group MAC Address, but do not carry the Slow
Protocols Ethernet Type.
Number of frames that carry the Slow Protocols Ethernet Type value, but
contain a badly formed PDU or an illegal value of Protocol Subtype.
4-188
4-207