Table 3-12 Recommended Sta Path Cost Range; Table 3-13 Recommended Sta Path Costs - Samsung iES4028F Management Manual

The following interface attributes can be configured:
• Spanning Tree – Enables/disables STA on this interface. (Default: Enabled).
• BPDU Flooding - Enables/disables the flooding of BPDUs to other ports when
global spanning tree is disabled (page 3-171) or when spanning tree is disabled on
specific port. When flooding is enabled, BPDUs are flooded to all other ports on the
switch or to all other ports within the receiving port's native VLAN as specified by
the Spanning Tree BPDU Flooding attribute (page 3-171).
• Priority – Defines the priority used for this port in the Spanning Tree Protocol. If
the path cost for all ports on a switch are the same, the port with the highest priority
(i.e., lowest value) will be configured as an active link in the Spanning Tree. This
makes a port with higher priority less likely to be blocked if the Spanning Tree
Protocol is detecting network loops. Where more than one port is assigned the
highest priority, the port with lowest numeric identifier will be enabled.
• Default: 128
• Range: 0-240, in steps of 16
• Admin Path Cost – This parameter is used by the STA to determine the best path
between devices. Therefore, lower values should be assigned to ports attached to
faster media, and higher values assigned to ports with slower media. (Path cost
takes precedence over port priority.)
(Range: 0 for auto-configuration, 1-65535 for the short path cost method
1-200,000,000 for the long path cost method)
By default, the system automatically detects the speed and duplex mode used on
each port, and configures the path cost according to the values shown below. Path
cost "0" is used to indicate auto-configuration mode. When the short path cost
method is selected and the default path cost recommended by the IEEE 8021w
standard exceeds 65,535, the default is set to 65,535.

Table 3-12 Recommended STA Path Cost Range

Port Type
Ethernet
Fast Ethernet
Gigabit Ethernet
Port Type
Ethernet
15. Refer to "Configuring Global Settings" on page 3-171 for information on setting the path
cost method.
IEEE 802.1D-1998
50-600
10-60
3-10

Table 3-13 Recommended STA Path Costs

Link Type IEEE 802.1D-1998
Half Duplex 100
Full Duplex 95
Trunk 90
Spanning Tree Algorithm Configuration
IEEE 802.1w-2001
200,000-20,000,000
20,000-2,000,000
2,000-200,000
IEEE 802.1w-2001
2,000,000
1,999,999
1,000,000
3
15
,
3-179