Table of Contents
Advertisement
− ENABLE : select to use the address book.
− DISABLE : select not to use the address book.
Destination Phone Number : Enter ISDN phone number of the destination
!
network. Enter ISDN phone number (7-8) digits, but do not enter '-' in the
middle of the phone number.
Destination Sub Address : Enter sub address of the destination network.
!
Sub address is used in North America only.
WAN IP Address : Enter IP address of the destination network router you
!
want to connect to.
WAN Subnet Mask : Enter subnet mask of the destination network router
!
you want to connect to.
WAN IP Status : To use IP(Internet Protocol), select 'ENABLE'.
!
After finishing setting up all the parameters above, click on the SET button. If you
want to make a new address book for another channel, click on the NEXT button to
enter the new destination network information. Then, click the SET button.
IP Static Route Setup
Static Routing is the way in which the network administrator establishes the routing
table. This is appropriate for an environment with predictable network traffic and
simple network design. In order to use IP static routing, first you have to create
routing tables using the IP Static Route Setup menu screen.
Channel : This is the connecting factor between the WAN and the routing table.
!
This will connect the address book that you chose in the PPP Setup menu and
the IP routing table. Select the address book that you want to connect to the IP
routing table.
Destination IP Address : Enter the IP address of the destination network
!
router that you want to connect to.
Destination Subnet Mask : Enter the subnet mask of the destination network
!
router that you want to connect to.
Gateway IP Address :
!
packet.
Note
Hops are routers that IP packets go through before arriving at the
destination network from the transmitting network.
Number of Hops :
!
before reaching the destination network. Normally this will be '1'.
Circuit Number : If you select X.25 for WAN protocol, enter the virtual circuit
!
number as X.25. If you select PPP for WAN protocol, enter '0'.
Static Route Status : If you set this parameter to 'ENABLE', the routing table
!
set up on this screen will be used.
After finishing setting up all the parameters above, click on the SET button. If you
want to make a new routing tabel for other channel, click on the NEXT button to
enter the new IP routing information. Then, click the SET button.
PPP Outgoing Security Setup
In order to automatically connect the DCS-VIP router to the ISP or remote router,
you need a login name and password. You enter the login name and the password
on the PPP Outgoing Security Setup screen. Set the following parameter values and
click the Set button.
Router Name : To use the account service, enter the login name provided by
!
the ISP or remote network administrator.
Router Password : To use account service, enter the password provided by
!
Enter the IP address of the next hop after transmitting
Enter the number of hops that a packet passes through
65
DCS-VIP User Guide
Advertisement
Table of Contents
