Samsung iES4028F Management Manual page 185

Field Attributes (CLI)
Basic Information:
• Port type – Indicates the port type. (100BASE-TX, 1000BASE-T, or SFP)
• MAC address – The physical layer address for this port. (To access this item on
the web, see "Setting the Switch's IP Address" on page 3-17.)
Configuration:
• Name – Interface label.
• Port Admin – Shows if the interface is enabled or disabled (i.e., up or down).
• Speed-duplex – Shows the current speed and duplex mode. (Auto, or fixed choice)
• Capabilities – Specifies the capabilities to be advertised for a port during
auto-negotiation. (To access this item on the web, see "Configuring Interface
Connections" on page 3-48.) The following capabilities are supported.
- 10half - Supports 10 Mbps half-duplex operation
- 10full - Supports 10 Mbps full-duplex operation
- 100half - Supports 100 Mbps half-duplex operation
- 100full - Supports 100 Mbps full-duplex operation
- 1000full - Supports 1000 Mbps full-duplex operation
- Sym - Transmits and receives pause frames for flow control
- FC - Supports flow control
• Broadcast Storm – Shows if broadcast storm control is enabled or disabled.
• Broadcast Storm Limit – Shows the broadcast storm threshold. (240-1488100
packets per second)
• Multicast Storm – Shows if multicast storm control is enabled or disabled.
• Multicast Storm Limit – Shows the multicast storm threshold. (64 - 1,000,000
kilobits per second)
• Unknown Unicast Storm – Shows if unknown unicast storm control is enabled or
disabled.
• Unknown Unicast Storm Limit – Shows the unknown unicast storm threshold.
(64 - 1,000,000 kilobits per second)
• Flow Control – Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port Security – Shows if port security is enabled or disabled.
• Max MAC Count – Shows the maximum number of MAC address that can be
learned by a port. (0 - 1024 addresses)
• Port Security Action – Shows the response to take when a security violation is
detected. (Display options: shutdown, trap, trap-and-shutdown, or none)
• Media Type – Shows the forced or preferred port type to use for combination ports
25-28 on iES4028F, 27-28 on iES4028FP, and 23-24 on iES4024GP.
(Display options: copper forced, SFP forced, SFP preferred auto)
• Giga PHY Mode – Shows the master/slave configuration mode used by negotiate
a 1000BASE-T full duplex connection for a link pair.
3
Port Configuration
3-129