Displaying Interfaces Attached To A Multicast Router; Figure 3-144 Igmp Immediate Leave - Samsung iES4028F Management Manual

3
Configuring the Switch
Command Attributes
• VLAN ID – VLAN Identifier. (Range: 1-4094).
• Immediate Leave – Sets the status for immediate leave on the specified VLAN.
(Default: Disabled)
Web – Click IGMP Snooping, IGMP Immediate Leave. Select the VLAN interface to
configure, set the status for immediate leave, and click Apply.
CLI – This example enables IGMP immediate leave for VLAN 1 and then displays
the current IGMP snooping status.
Console(config)#interface vlan 1
Console(config-if)#ip igmp snooping immediate-leave
Console(config-if)#end
Console#show ip igmp snooping
Service Status:
Querier Status:
Leave proxy status:
Query Count:
Query Interval:
Query Max Response Time: 10 sec
Router Port Expire Time: 300 sec
Immediate Leave Processing: Enabled on VLAN
IGMP Snooping Version:
Console#

Displaying Interfaces Attached to a Multicast Router

Multicast routers that are attached to ports on the switch use information obtained
from IGMP, along with a multicast routing protocol such as DVMRP or PIM, to
support IP multicasting across the Internet. These routers may be dynamically
discovered by the switch or statically assigned to an interface on the switch.
You can use the Multicast Router Port Information page to display the ports on this
switch attached to a neighboring multicast router/switch for each VLAN ID.
Command Attributes
• VLAN ID – ID of configured VLAN (1-4094).
• Multicast Router List – Multicast routers dynamically discovered by this switch or
those that are statically assigned to an interface on this switch.
3-256

Figure 3-144 IGMP Immediate Leave

Enabled
Disabled
Enabled
2
125 sec
Version 2
1,
4-327
4-326