Time Commands; Table 4-19 Time Commands - Samsung iES4028F Management Manual

Example
Console#show logging sendmail
SMTP servers
-----------------------------------------------
1. 192.168.1.200
SMTP minimum severity level: 4
SMTP destination email addresses
-----------------------------------------------
1. geoff@samsung.com
SMTP source email address:
SMTP status:
Console#

Time Commands

The system clock can be dynamically set by polling a set of specified time servers
(NTP or SNTP). Maintaining an accurate time on the switch enables the system log
to record meaningful dates and times for event entries. If the clock is not set, the
switch will only record the time from the factory default set at the last bootup.
Command
SNTP Commands
sntp client
sntp server
sntp poll
show sntp
NTP Commands
ntp client
ntp server
ntp poll
ntp authenticate
ntp authentication-key Configures authentication keys
show ntp
Manual Configuration Commands
clock
timezone-predefined
clock timezone
clock summertime
(date)
clock summertime
(predefined)
john@samsung.com
Enabled

Table 4-19 Time Commands

Function
Accepts time from specified time servers
Specifies one or more time servers
Sets the interval at which the client polls for time
Shows current SNTP configuration settings
Enables the NTP client for time updates from specified servers GC
Specifies NTP servers to poll for time updates
Sets the interval at which the NTP client polls for time
Enables authentication for NTP traffic
Shows current NTP configuration settings
Sets the time zone for the switch's internal clock using
predefined time zone configurations
Manually sets the time zone for the switch's internal clock
Configures summer time (daylight savings time) for the switch's
internal clock
Configures summer time (daylight savings time) for the switch's
internal clock
System Management Commands
4
Mode Page
GC 4-60
GC 4-61
GC 4-61
NE, PE 4-62
4-62
GC 4-63
GC 4-64
GC 4-64
GC 4-65
NE, PE 4-66
GC 4-67
GC 4-67
GC 4-68
GC 4-69
4-59