Telnet Server Commands; Ip Telnet Server; Table 4-36 Telnet Server Commands - Samsung iES4028F Management Manual

4
Command Line Interface
Default Setting
443
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same port.
• If you change the HTTPS port number, clients attempting to connect to the
HTTPS server must specify the port number in the URL, in this format:
https://device:port_number
Example
Console(config)#ip http secure-port 1000
Console(config)#
Related Commands
ip http secure-server (4-124)

Telnet Server Commands

Command

ip telnet server

ip telnet server
This command allows this device to be monitored or configured from Telnet. It also
specifies the TCP port number used by the Telnet interface. Use the no form without
the "port" keyword to disable this function. Use the no from with the "port" keyword
to use the default port.
Syntax
ip telnet server [port port-number]
no telnet server [port]
• port - The TCP port used by the Telnet interface.
• port-number - The TCP port number to be used by the browser interface.
(Range: 1-65535)
Default Setting
• Server: Enabled
• Server Port: 23
Command Mode
Global Configuration
4-126

Table 4-36 Telnet Server Commands

Function
Allows the switch to be monitored or configured from Telnet; also
specifies the port to be used by the Telnet interface
Mode Page
GC 4-124