Table of Contents
Advertisement
Body Electrical
General Troubleshooting Information
• Check for loose retainer (A) and rubber seals (B).
A
• The backs of some connectors are packed with
grease. Add grease if necessary. If the grease is
contaminated, replace it.
* Insert the connector all the way and make sure it is
securely locked.
• Position wires so that the open end of the cover faces
down.
(cont'd)
Handling Wires and Harnesses
• Secure wires and wire harnesses to the frame with
their respective wire ties at the designated locations.
• Remove clips carefully; don't damage their locks (A).
• Slip pliers (A) underthe clip base and through the
hole at an angle, then squeeze the expansion tabs to
release the clip.
A
• After installing harness clips, make sure the harness
doesn't interfere with any moving parts.
• Keep wire harnesses away from exhaust pipes and
other hot parts, from sharp edges of brackets and
holes, and from exposed screws and bolts.
• Seat grommets in their grooves properly (A). Do not
leave grommets distorted (B).
22-4
Advertisement
Table of Contents
Troubleshooting
