Doors
Rear Door Panel Removal/Installation (cont'd)
3. Power window models: Remove the pull pocket
panel (A). Take care not to scratch the door panel.
- 1 Pry out the cap (B), and remove the screw.
- 2 Release the hooks (C), and disconnect the
power window switch connector (D).
F a s t e n e r L o c a t i o n
•
: S c r e w , 1
4. Manual window model: Remove the pull pocket (A).
Take care not to scratch the door panel.
- 1 Pry out the cap (B), and remove the screw.
- 2 Lift out the pull pocket.
F a s t e n e r L o c a t i o n
•
: S c r e w , 1
Release the clips that hold the door panel (A) with a
(commercially available) trim pad remover (B), then
remove the door panel by pulling it upward, and
removing the courtesy light bulb socket (C).
Remove the door panel with as little bending as
possible to avoid creasing or breaking it.
9 5 m m
(3.74
in.)
12 m m
(0.47 in.)
1 m m
(0.04 in.)
4 5 m m
(1.77 in.)
F a s t e n e r L o c a t i o n s
t > : C l i p , 7
/ / /
/
20-18