Honda 2002 Accord Manual page 1598

S R S
DTC Troubleshooting - '01-02 Mode
DTC 12-1: Open or increased resistance in
front passenger's side airbag inflator
1. Erase the DTC m e m o r y (see page 23-45).
2. T u r n the ignition switch O N (II), and check that the
SRS indicator light c o m e s on f o r about 6 seconds
and t h e n goes off.
Does the SRS indicator light stay on?
Y E S - G o t o step 3.
NO — Intermittent failure, system is OK at this t i m e .
Go t o Troubleshooting Intermittent Failures (see
page 23-45).
3. T u r n the ignition switch OFF. Disconnect the
battery negative cable, and w a i t for 3 minutes.
4. Disconnect the right side w i r e harness 2P
connector (A) f r o m the front passenger's side
airbag (B).
0 7 X A Z - S 1 A 0 2 0 0
5. Connect the special tool (2 Q connector) to the
right side wire harness 2P connector.
w i t h Side Airbags (cont'd)
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
8. Read the DTC.
Is DTC 12-1 indicated?
Y E S - G o t o step 9.
NO—Open or increased resistance in the front
passenger's side airbag inflator; replace the front
passenger's side airbag (see page 23-282).•
9. Disconnect the battery negative cable, and wait for
3 minutes.
10. Disconnect the right side w i r e harness 4P
connector C583 (A) f r o m the SRS main harness 4P
connector (B).
11. Connect the special tool (2 Q connectors) to the
SRS main harness 4P connector.
12. Reconnect the battery negative cable.
13. Erase the DTC memory.
14. Read the DTC.
Is DTC 12-1 indicated?
Y E S - G o t o step 15.
NO—Open or increased resistance in the right side
wire harness; replace the right side w i r e harness. •
15. Disconnect the battery negative cable, and wait for
3 minutes.
23-218