Honda 2002 Accord Manual page 969

6. To remove a front drain valve (A) from the body
remove the kick panel, left or right (Sedan (see
page 20-75), Coupe (see page 20-74)). Tie a string to
the end of the front drain tube (B) then pull the
drain tube down out of the front pillar.
7. To remove a rear drain valve (A) from the body,
remove these parts (see page 20-78):
• Trunk floor
• Trunk side trim panel
• Trunk side pocket, left or right
Tie a string to the top end of the rear drain tube (B),
then pull back the trunk side trim panel and pull the
drain tube down out of the pillar.
8. Install the frame and drain tubes in the reverse
order of removal, and note these items:
• Before installing the frame, clear the drain tubes
and drain valves using compressed air.
• Check the frame seal.
• Clean the surface of the frame.
• When installing the frame, first attach the rear
hooks into the body holes.
• Make sure the connectors are plugged in
properly.
• When connecting the drain tube, slide it over the
frame nozzle at least 10 mm (0.39 in.).
• Install the tube clip (A) on the drain tube (B) as
shown.
9. Check for water leaks. Let the water run freely from
a hose without a nozzle. Do not use a high-pressure
spray.
20-67