Table of Contents
Advertisement
SRS
DTC Troubleshooting - '01-02 Models w i t h Side Airbags (cont'd)
11. Disconnect SRS unit connector B (14P) f r o m t h e
SRS unit. Do not disconnect the special tool f r o m
the left side wire harness 2P connector.
12. Check resistance between t h e N o . 4 and No. 13
terminals of SRS connector B (14P). There should
be 2 . 0 - 3 . 0 0 .
S R S U N I T C O N N E C T O R B ( 1 4 P )
•-
i
n
a
1
4
5
6
7
a
/
11 12 13
14
a
W i r e s i d e o f f e m a l e t e r m i n a l s
Is the resistance
as
specified?
YES - Faulty SRS unit or poor contact at the SRS
main harness 14P connector and t h e SRS unit;
check the connection at the SRS m a i n harness 14P
connector and SRS unit. If the connector is OK,
replace t h e SRS unit (see page 23-296). •
NO—Open or increased resistance in the SRS m a i n
harness or left side wire harness; replace the faulty
harness. •
DTC 11-3: Short to another wire or decreased
resistance in driver's side airbag inflator
1. Erase the DTC m e m o r y (see page 23-45).
2. Turn the ignition switch ON (II), and check that the
SRS indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay
on?
Y E S - G o t o step 3.
NO—Intermittent failure, system is OK at this time.
Go t o Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the left side w i r e harness 2P connector
(A) f r o m t h e driver's side airbag (B).
07SAZTB4011A
07XAZ-S1A0200
5. Connect the special tool (2 Q connector) t o the left
side w i r e harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
23-212
Advertisement
Table of Contents
Troubleshooting
