Table of Contents
Advertisement
SRS
Precautions and Procedures (cont'd)
W i r i n g Precautions
SRS w i r i n g can be identified by special yellow outer
covering (except the SRS indicator light circuit).
Observe the instructions described in this section.
• Never attempt to modify, splice, or repair SRS w i r i n g .
If there is an open or damage in SRS w i r i n g , replace
the harness.
• Be sure to install the harness w i r e s so they do not get
pinched or interfere with other parts.
* Make sure all SRS ground locations are clean, and
grounds are securely fastened f o r o p t i m u m metal-to-
metal contact. Poor grounding can cause intermittent
problems that are difficult to diagnose.
Precautions for Electrical Inspections
• When using electrical test equipment, insert the
probe of the tester into the w i r e side of the connector.
Do not insert the probe of the tester into the terminal
side of the connector, and do not tamper w i t h the
connector.
• Use a U-shaped probe. Do not insert the probe
forcibly.
• Use specified service connectors in troubleshooting.
Using improper tools could cause an error in
inspection due to poor metal-to-metal contact.
23-32
Advertisement
Table of Contents
Troubleshooting
