Honda 2002 Accord Manual page 953

14. Glue the fasteners (A, B) and spacers (U.S.-
Produced); (C) to the inside face of the rear window
as shown. If necessary, apply primer (3M N-200, or
equivalent) to the areas where the window antenna
terminal base (D) will be glued, then glue the base
on:
• Be sure the fasteners, spacers (and window
antenna terminal base cover) line up with the
alignment marks (E).
• Be careful not to touch the rear window where
adhesive will be applied.
U.S.-Produced models:
: A p p l y p r i m e r h e r e .
F a s t e n e r a n d s p a c e r L o c a t i o n s
B t>: F a s t e n e r
C o u p e , 2 ( b o t h s i d e s )
S e d a n , 3 ( b o t h s i d e s a n d c e n t e r )
C [ > : S p a c e r , 2
1 3 . 5 m m
(0.53 in
Japan produced models:
'///////// : A p p l y p r i m e r h e r e .
F a s t e n e r L o c a t i o n s
A O : F a s t e n e r , 2
1 3 . 5 m m
(0.53 i n .
B > : F a s t e n e r , 2
1 3 . 5 m m
(0.53 in.)
15. Apply the adhesive tape (A) (3M 4216, or
equivalent) to the edge of the rear window (B):
• Be sure the adhesive tape lines up with the
alignment marks (C).
• Be careful not to touch the rear window where
adhesive will be applied.
5 m m
(0.2 in.)
(cont'd)
20-51