Table of Contents
Advertisement
S R S
DTC Troubleshooting - '01-02 Models w i t h Side Airbags (cont'd)
DTC 11-4; S h o r t to power in driver's side
airbag inflator
1. Erase the D T C memory (see page 23-45).
2. Turn the ignition switch ON (II), and check that the
S R S indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay on?
Y E S
Go to step 3.
NO
Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the left side wire harness 2P connector
(A) from the driver's side airbag (B).
0 7 S A 2 - T B 4 0 1 1 A
0 7 X A Z - S 1 A 0 2 0 0
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 11-4
indicated?
Y E S - G o t o step 9.
NO —Short to power in the driver's side airbag
inflator; replace the driver's side airbag (see page
23-282). •
9. Disconnect the battery negative cable, and wait for
3 m i n u t e s . •
10. Disconnect the right side wire harness 2P
connector (A) from the front passenger's side
airbag (B), and disconnect the special tool from the
left side wire harness 2P connector.
5. Connect the special tool (2 Q connector) to the left
side wire harness 2P connector.
23-214
Advertisement
Table of Contents
Troubleshooting
