Table of Contents
Advertisement
DTC 13-4; Faulty power supply to the driver's
side impact sensor
1. Erase the DTC m e m o r y (see page 23-45).
2. T u r n the ignition switch ON (II), and check that the
SRS indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay
on?
Y E S - G o t o step 3.
NO— Intermittent failure, system is OK at this time.
Go t o Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
negative battery cable, and wait for 3 minutes.
4. Disconnect the side w i r e harness 2P connectors
f r o m the driver's and f r o n t passenger's side
airbags.
A
5. Disconnect the left side w i r e harness 2P
connector (A) f r o m the driver's side impact
sensor (B).
6. Disconnect SRS unit connector B (14P) f r o m the
SRS unit.
(cont'd)
23-157
Advertisement
Table of Contents
Troubleshooting
