Steering Hanger Beam Replacement - Honda 2002 Accord Manual

Dashboard
Steering Hanger Beam Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the dashboard (see page 20-90).
2. Remove the following parts from the dashboard:
• Gauge assembly (see page 22-68)
• Audio unit (see page 22-124)
3. From under the middle of the dash: release the
passenger's airbag connector (A) from the
connector holder (B), and disconnect the connector.
Detach the harness clips (C), and remove the
ground bolts (D).
C C A
6 x 1.0 m m
9 . 8 N m (1.0 k g f m , 7.2 Ibf ft)
4. From the driver's side, if applicable, disconnect and
detach the S R S wire harness connector (A).
If equipped, disconnect the cruise control unit
connector (B).
5. Disconnect the dashboard wire harness connectors
(A) from the right (passenger's) fuse box (B).
Detach the harness clip (C) and connector clip (D),
and remove the ground bolt (E).
6 x 1.0 m m
9.8 N m (1.0 kgf-m, 7.2 I b f f t )
20-94