Table of Contents
Advertisement
SRS
DTC Troubleshooting - '01-02 Models (cont'd)
DTC 4-1; Open in right side seat belt
tensioner
DTC 4-2: Increased resistance in right side
seat belt tensioner
1. Erase the DTC memory (see page 23-45).
2. Turn the ignition switch ON (II), and check that the
S R S indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay on?
Y E S - G o t o step 3.
NO —intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the right side seat belt tensioner 2P
connector from the right side wire harness 2P
connector (A).
0 7 T A Z - S Z 5 0 1 1 A
5. Connect the special tool (2 Q connector) to the
right side wire harness 2P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
Is DTC 4-1 or DTC 4-2
indicated?
Y E S - G o t o step 9.
N O - O p e n or increased resistance in right side
seat belt tensioner; replace the right side seat belt
(see page 23-4). •
9. Disconnect the battery negative cable, and wait for
3 minutes.
10. Disconnect the driver's airbag connector (A), front
passenger's airbag connector (B), and left side seat
belt tensioner connector (C).
23-196
Advertisement
Table of Contents
Troubleshooting
