Erasing The Dtc Memory (Srs); Troubleshooting Intermittent Failures (Srs) - Honda 2002 Accord Manual

Hide thumbs Also See for 2002 Accord:
Table of Contents

Advertisement

Erasing t h e DTC M e m o r y
Troubleshooting Intermittent Failures
Special Tools Required
SCS Service Connector 07PAZ-0010100
To erase the DTC(s) f r o m the SRS unit, use a Honda
PGM Tester (see the Honda PGM Tester SRS Vehicle
System Supplement) or the f o l l o w i n g procedure.
1. Make sure the ignition switch is OFF.
2. Connect the SCS service connector (A) to the MES
connector (2P)(B). Do not use a jumper wire.
0 7 P A Z - 0 0 1 0 1 0 0
If there was a malfunction, but it doesn't recur, it will be
stored in the m e m o r y as an intermittent failure, and the
SRS indicator light will come on.
After checking the DTC, troubleshoot as f o l l o w s :
1. Read the DTC (see "Reading the DTC").
2. Erase the DTC memory (see "Erasing the DTC
M e m o r y " ) .
3. W i t h the shift lever in Park or neutral, start the
engine, and let the engine idle.
4. The SRS indicator light w i l l come on for about 6
seconds and then go off.
5. Shake the wire harness and the connectors, take a
test drive (quick acceleration, quick braking,
cornering), turn the steering wheel fully left and
right, and hold it there for 5 to 10 seconds. If the
problem recurs, the SRS indicator light w i l l come
on.
6. If you can't duplicate the intermittent failure, the
system is OK at this time.
3. Turn the ignition switch ON (II).
4. The SRS indicator light w i l l come on for about 6
seconds, and then go off. Remove the SCS service
connector f r o m the MES connector (2P) w i t h i n 4
seconds after the light goes off.
5. The SRS indicator light will come on again.
Reconnect the SCS service connector to the MES
connector (2P) w i t h i n 4 seconds after the light
comes o n .
6. When the SRS indicator light goes off, remove the
SCS service connector f r o m the MES connector (2
P) w i t h i n 4 seconds.
7. The SRS indicator light will blink t w o times
indicating that the m e m o r y has been erased.
8. Turn the ignition switch OFF, and wait for 10
seconds.
9. Turn the ignition switch ON (II) again. The SRS is
OK if the SRS indicator light comes on for 6
seconds, and then goes off.
(cont'd)
23-45

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

2000 accord1999 accord1998 accordAccord 1998-2002Accord 1998Accord 1999 ... Show all

Table of Contents