Honda 2002 Accord Manual page 1586

S R S
DTC Troubleshooting - # 00-02 Models (cont'd)
12. Connect No. 2 terminal of the driver's seat wire
harness 3P connector to body ground with a
jumper wire.
D R I V E R ' S S E A T
W I R E H A R N E S S 3 P C O N N E C T O R
J U M P E R W I R E
W i r e s i d e o f f e m a l e t e r m i n a l s
Does the seat belt reminder come on?
Y E S - G o to step 13.
NO—Open in the driver's seat wire harness, driver's
under-dash fuse/relay box, or dashboard wire
harness A. Isolate the faulty harness, and replace
the harness or component as necessary. •
13. Turn the ignition switch OFF, and disconnect the
negative cable from the battery.
14. Disconnect all S R S unit connectors from the S R S
unit, and reconnect the battery.
15. Connect the No. 4 terminal of S R S unit connector
C (8P) to body ground with a jumper wire. Turn the
ignition switch ON (II).
S R S U N I T C O N N E C T O R C (8P)
J U M P E R W I R E
1 2 3 4
5 6
7
8
W i r e s i d e o f f e m a l e t e r m i n a l s
Does the seat belt reminder come on?
Y E S — Disconnect the jumper wire, then go to step
18.
NO —Open in dashboard wire harness A. Replace
dashboard wire harness AM
16. Turn the ignition switch OFF, and disconnect the
negative cable from the battery.
17. Disconnect S R S unit connector C (8P), reconnect
the battery, and turn the ignition switch ON (II).
Does the seat belt reminder come on?
Y E S —Short to ground in the dashboard wire
harness A, driver's under-dash fuse/relay box
(without heated seat), driver's multiplex control
unit (without heated seat), left side wire harness,
driver's power seat wire harness (with power seat),
or gauge assembly/circuit board. Replace the faulty
harness or component. •
N O - R e p l a c e the S R S unit (see page 23-296).•
23-206