Honda 2002 Accord Manual page 806

Front Suspension
Knuckle/Hub Replacement (cont'd)
12. Remove the cotter pin (A) f r o m the tie-rod e n d ball
joint, then loosen the nut (B).
0 7 M A C - S L 0 0 2 0 0 3 2 I b f f t )
13. Remove the tie-rod ball joint f r o m the knuckle using
the special tool (see page 18-9).
14. Remove the cotter pin (A) f r o m the lower a r m ball
joint castle nut (B), and remove the nut.
0 7 M A C - S L 0 0 2 0 0
15. Remove the lower ball joint f r o m the knuckle using
the special tool (see page 18-9).
16. Remove the cotter pin (A) f r o m the upper bail joint
castle nut (B), and remove the nut.
0 7 M A C - S L 0 0 2 0 0
2 9 - 3 5 I b f f t )
17. Remove the upper ball joint f r o m the knuckle using
the special tool (see page 18-9).
18. Pull the knuckle o u t w a r d , and remove the
driveshaft outboard joint (B) f r o m the knuckle (A)
by tapping the driveshaft end ( C ) w i t h a plastic
hammer, then remove the knuckle.
B C
18-12