Table of Contents
Advertisement
Rack Guide Adjustment
Special Tools Required
Locknut wrench, 40 mm, 07916-SA50001
1. Set the wheels in the straight ahead position.
2. Loosen the rack guide screw locknut (A) with the
special tool, then remove the rack guide screw (B).
A
0 7 9 1 6 - S A 5 0 0 0 1
3. Remove the old sealant from rack guide screw, and
apply new sealant all around the threads (C).
Loosely install the rack guide screw on the steering
gearbox.
7. Check for unusual steering effort through the
complete turning travel.
8. Check the steering wheel rotational play and the
power assist (see page 17-7).
4. Tighten the rack guide screw to 25 N-m (2.5 kgf-m,
18 Ibf ft), then loosen it.
5. Retighten the rack guide screw to 3.9 N-m (0.4 kgf-
m, 2.9 Ibf-ft) then back it off to specified angle.
Specified Return Angle:
20°
6. Tighten the locknut while holding the rack guide
screw.
17-29
Advertisement
Table of Contents
Troubleshooting
