Park Lever Stop Inspection And Adjustment - Honda 2002 Accord Manual

Transmission End Cover
Park Lever Stop Inspection and Adjustment
1. Set the park lever in the E position.
2. Measure the distance (A) between the park pawl
shaft (B) and the park lever roller pin (C).
STANDARD:
69.5 - 70.5 m m (2.74 - 2.78 in.)
A * / \
C
14 N m ( 1 . 4 k g f m , 10 Ibf ft)
3. If the measurement is out of tolerance, select and
install the appropriate park lever stop (A) from the
table below.
PARK LEVER S T O P
Mark
Part Number
Li L
2
1 24537-PA9-003 11.00 mm
(0.433 in.)
11.00 mm
(0.433 in.)
2 24538-PA9-003 10.80 mm
(0.425 in.)
10.65 mm
(0.419 in.)
3 24539-PA9-003 10.60 mm
(0.417 in.)
10.30 mm
(0.406 in.)
4. After replacing the park lever stop, make sure the
distance is within tolerance.
14-152