Table of Contents
Advertisement
11. Disconnect S R S unit connector A (18P) from the
S R S unit
12. Check resistance between the No. 6 and No. 15
terminals and between the No. 5 and No. 14
terminals of S R S unit connector A (18P). There
should be 2.0-3.0 Q .
S R S U N I T C O N N E C T O R A ( 1 8 P )
r
d
n
3
4
5
6
7
d
n
/
12 13 14 15 16
/
d
n n
W i r e s i d e o f f e m a l e
t e r m i n a l s
Is the resistance
as
specified?
Y E S - F a u l t y S R S unit or poor contact at the S R S
unit connector; check the connection between the
SRS main harness 18P connector and the S R S unit.
If the connector is OK, replace the S R S unit (see
page 23-296). •
NO —Open or increased resistance in the S R S main
harness; replace the S R S main harness. •
DTC 2-3: Short t o another wire or decreased
resistance in passenger's airbag inflator.
1. Erase the DTC memory (see page 23-45).
2. Turn the ignition switch ON (II), and check that the
S R S indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay
on?
Y E S - G o to step 3.
NO —Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures (see
page 23-45).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector from the S R S main harness 4P
connector (A).
0 7 X A Z - S Z 3 0 1 0 0
5. Connect the special tool (2 Q connectors) to the
S R S main harness 2P connector.
(cont'd)
23-101
Advertisement
Table of Contents
Troubleshooting
