Honda 2002 Accord Manual page 703

7. Install three dowel pins and a new gasket on the
torque converter housing.
8. Place the transmission housing on the torque
converter housing, then install the housing bolts
along with the transmission hanger/connector
bracket (A), transmission hangers (B), and
transmission ground terminal bracket (C). Tighten
the bolts and new special bolt ('01-02 models) (D) in
two or more steps in the sequence shown to 44 N-
m (4.5kgfm, 33 Ibfft).
9. Install the ATF feed pipes (A) with their filter (B)
side into the transmission housing, then install new
O-rings (C), new gasket (D), harness clamp bracket
(E) and the A/T clutch pressure control solenoid
valves A and B (F) over the ATF feed pipes on the
transmission housing.
E F B
10. Coat the reverse idler gear shaft (A), needle bearing
(B), and new O-rings (C) with lithium gearse lightly.
Assemble the new O-rings and needle bearing on
the reverse idler gear shaft, then install the reverse
idler gear shaft in the reverse idler gear shaft
holder (D). Align the D-shaped cut out of the shaft
with the D-shaped area of the holder.
D
11. Engage the reverse idler gear (A) with the
countershaft reverse gear and mainshaft reverse
gear, then install the reverse gear shaft/holder
assembly (B) on the transmission housing.
6 x 1.0 m m
1 2 N m (1.2 k g f m , 8.7 I b f f t )
14-193