Honda 2002 Accord Manual page 709

29. Install the transmission range switch (A) loosely on
the control shaft ( B ) , then secure it with the bolts.
Do not move the transmission range switch when
tightening the bolts.
6 x 1.0 m m
12 N m ( 1 . 2 k g f m , 8.7 I b f f t )
6 x 1.0
mm
12 N m (1.2 kgfm, 8.7 Ibfft)
6 x 1.0
mm
12 N-m (1.2 kgfm,
30. Install the transmission range switch cover (C), and
install the harness clamp on the clamp bracket (D)
on the transmission housing, then install the
harness clamp (E) on the end cover (F).
31. Install the ATF cooler lines and new sealing
washers. Tighten the line fittings to 28 N-m (2.9
kgf-m, 21 Ibf-ft).
32. Install the breather tube.
33. Install the ATF dipstick.
For '01-02 models, follow this procedure:
34. Install the rear stiffener (A), then tighten the 10 x
1.25 mm bolt (B) to the specified torque.
10 x 1.25 m m
4 4 N m ( 4 . 5 k g f m , 3 3 I b f f t )
8 x 1.25 m m
2 6 N m
(2.7 k g f m , 2 0 I b f f t )
10 x 1.25 m m
4 4 N - m (4.5 k g f m , 3 3 Ibf-ft)
35. Secure the nut (C) by your hand until it contacts the
stiffener, then tighten it to the specified torque. If
you can not tighten the nut to the stiffener surface
by hand, replace the nut and the special bolt (D).
14-199