Honda 2002 Accord Manual page 788

Power Steering
Steering Gearbox Overhaul (cont'd)
65. Attach the yoke of a universal puller (A) to the
steering gearbox mounts with bolts, then clamp the
yoke in a vise with soft jaws. Do not clamp the
cylinder housing or gearbox housing in the vise.
A
66. Coat the inside surface of the cylinder end (A) with
power steering fluid, then install the cylinder end
by screwing it into the cylinder (B).
68. Coat the new O-ring (A) with grease, and carefully
fit it on the valve housing.
D
2 0 N m (2.0 k g f m , 14 I b f f t )
69. Apply grease to the needle bearing (B) in the
gearbox housing, then install the valve body unit
(C) by engaging the gears. Note the valve body unit
installation position (direction of the line
connections).
70. Tighten the flange bolts (D) to the specified torque.
A
C
6 9 N - m {7.0 k g f m , 51 I b f f t )
67. Remove the yoke from the gearbox, then, after
tightening the cylinder end (C), stake the point of
the cylinder shown (opposite from where the stake
was removed during disassembly).
17-44