A / T Differential
Carrier Bearing Outer Race Replacement
Special Tools Required
•Driver 07749-0010000
• Driver attachment 07HAD-SF10100
NOTE:
• Replace the bearing with a new one whenever the
outer race is to be replaced.
• Do not use shim (s) on the torque converter housing
side.
• Adjust preload after replacing the bearing and outer
race.
• Coat all parts with ATF during installation.
1. Remove the bearing outer race from the
transmission housing by heating the housing to
about 212°F (100°C) with a heat gun. Do not heat
the housing more than 212°F (100°C).
2. Remove the bearing outer race from the torque
converter housing.
3. Install the thrust shim (A), thrust washer (B) and
outer race (C) in the transmission housing (D) with
the special tools.
0 7 7 4 9 - 0 0 1 0 0 0 0
0 7 H A D S F 1 0 1 0 0
4. Install the thrust washer (A) and outer race (B) in
the torque converter housing (C), and be sure to
install the outer race until it bottoms is the housing
with the special tools.
0 7 H A D - S F 1 0 1 0 0
14-204