Table of Contents
Advertisement
SRS
DTC Troubleshooting - '98-99 Models (cont'd)
5. Disconnect the S R S main harness 18P
connector (A) from the S R S unit (B).
6. Reconnect the battery negative cable.
7. Turn the ignition switch ON (II).
8. Check for voltage between the No. 10 terminal of
the S R S main harness 18P connector and body
ground, and between the No. 14 terminal and body
ground. There should be 0.5 V or less.
S R S M A I N H A R N E S S 1 8 P C O N N E C T O R
9. Check for voltage between the No. 1 terminal of the
SRS main harness 18P connector and body ground,
and between the No. 13 terminal and body ground.
There should be 0.5 V or less.
S R S M A I N H A R N E S S 1 8 P C O N N E C T O R
/
3
/ /
6
7
8
10
13 14 15
16
17 18
W i r e s i d e o f f e m a l e
t e r m i n a l s .
Is the voltage as
specified?
Y E S - F a u l t y S R S unit; replace the S R S unit (see
page 23-295). •
N O - G o t o step 10.
10. Turn the ignition switch OFF.
/
3
6
7
8
9
1
10
/ /
13 14 15
16
17 18
W i r e s i d e o f f e m a l e
t e r m i n a l s .
Is the voltage as
specified?
Y E S - G o to step 9.
NO —Short to power in the S R S main harness;
replace the S R S main harness. •
23-90
Advertisement
Table of Contents
Troubleshooting
