Hood Seal Rubber And Hood Molding Replacement - Honda 2002 Accord Manual

Hood Seal Rubber and Hood Molding
1. Using a clip remover, detach the clips, then remove
the hood seals (A). On Canadian models, remove
the hood molding (B). On '00-02 Canadian Coupe
model, Carefully peel the hood molding adhesive
tapes (F) off of the hood. Take care not to scratch
the hood.
Coupe:
Adhesive tape ('00-02 models):
3M3511, or equivalent
Thickness:
1 mm (0.04 in.)
Width: 5 mm (0.2 in.)
Fastener Locations
C > : C l i p , 1 2 D > : C l i p , 9
' 9 8 - ' 9 9 m o d e l s :
Replacement
Sedan:
Fastener Locations
C > : C l i p , 1 2 D l > : C l i p , 7
A
2. Install the hood seal and hood molding in the
reverse order of removal, and note these items:
• Replace any damaged clips.
• On '00-02 Canadian Coupe model: If the old hood
molding is to be reinstalled, scrape off all traces
of the old adhesive tape, then clean the molding
surface with alcohol. Apply primer (3M K500, or
equivalent) to the hood molding where the new
adhesive tape will attach, then give the molding
into place securely with new adhesive tape.
20-153