Table of Contents
Advertisement
4
12. Check resistance between the No. 4 and No. 13
t e r m i n a l s of SRS unit connector B(14P). There
should be 2 . 0 - 3 . 0 Q .
S R S U N I T C O N N E C T O R B ( 1 4 P )
_
.
J
l
r
1
4
5
6
7
/
11
12
13
14
W i r e s i d e o f f e m a l e t e r m i n a l s
Is the resistance
as
specified?
Y E S —Faulty SRS unit or poor contact at SRS unit
connector B (14P) and the SRS unit; check the
connection. If the connector is OK, replace the SRS
unit (see page 23-296). •
NO —Open or increased resistance in the SRS floor
harness; replace the SRS floor harness. •
DTC 11-3: Short to another wire or decreased
resistance in driver's side airbag inflator
1. Erase the DTC m e m o r y (see page 23-45).
2. T u r n the ignition switch ON (II), and check that the
SRS indicator light comes on for about 6 seconds
and then goes off.
Does the SRS indicator
light stay
on?
Y E S - G o to step 3.
N O —Intermittent failure, system is OK at this t i m e .
Go t o Troubleshooting Intermittent Failures (see
page 23-45).
3. Disconnect the battery negative cable, and wait f o r
3 minutes.
4. Disconnect the SRS floor harness 2P connector (A)
f r o m the driver's side airbag (B).
5. Connect the special tool (2 Q connector) to the SRS
floor harness 2 P connector.
6. Reconnect the battery negative cable.
7. Erase the DTC m e m o r y .
(cont'd)
23-109
Advertisement
Table of Contents
Troubleshooting
