Honda 2002 Accord Manual page 1544

S R S
DTC Troubleshooting - '00 Coupe w i t h Side Airbags (cont'd)
12. Check for voltage between the No. 9 terminal of the
dashboard wire harness A 16P connector C582 and
body ground. There should be battery voltage.
D A S H B O A R D W I R E H A R N E S S A
1 6 P C O N N E C T O R ( C 5 8 2 )
/ 9 10
1 1
2 1 3 2
_ 5 B _
V ) W i r e s i d e o f f e m a l e
J t e r m i n a l s
Is there battery voltage?
Y E S —Open in the right side wire harness or OPDS
unit harness: if the OPDS unit harness is OK,
replace the S R S floor h a r n e s s . •
NO —Open in dashboard wire harness A: replace
dashboard wire harness A . B
13. Replace the No. 7 (7.5A) fuse in the driver's under-
dash fuse/relay box.
14. Turn the ignition switch ON (II) for 30 seconds, then
turn it OFF.
15. Check the No. 7 (7.5A) fuse in driver's under-dash
fuse/relay box.
Is the fuse OK?
Y E S - F i n i s h e d . •
N O - G o to step 16.
16. Replace the No. 7 (7.5A) fuse in the driver's under-
dash fuse/relay box.B
17. Disconnect the dashboard wire harness connector
I (18P) from the driver's under-dash fuse/relay box.
18. Turn the ignition switch ON (II) for 30 seconds, then
turn it off.
19. Check the No. 7 (7.5A) fuse in the driver's under-
dash fuse/relay box.
Is the fuse OK?
Y E S - G o t o step 20.
N O - S h o r t to ground in the No. 7 (7.5A) circuit-
refer to section 22 and continue troubleshooting. •
20. Disconnect the right side wire harness 16P
connector C582 (A) from the dashboard wire
harness A 16P connector (B).
23-164